LM2575T-3.3 ON Semiconductor IC REG MULT CONFG INV 3.3V TO220

CategoriesIntegrated Circuits (ICs)
PMIC - Voltage Regulators - DC DC Switching Regulators
Manufacturer ON Semiconductor
Series-
Packaging Tube

Part StatusObsolete
FunctionStep-Up, Step-Down, Step-Up/Step-Down
Output ConfigurationPositive or Negative
TopologyBuck, Boost, Buck-Boost
Output TypeFixed
Number of Outputs1
Voltage - Input (Min)4.75V
Voltage - Input (Max)40V
Voltage - Output (Min/Fixed)3.3V
Voltage - Output (Max)-
Current - Output1A
Frequency - Switching52kHz
Synchronous RectifierNo
Operating Temperature-40°C ~ 125°C (TJ)
Mounting TypeThrough Hole
Package / CaseTO-220-5
Supplier Device PackageTO-220-5

Base Part Number LM2575

　　The LM2575 series of regulators are monolithic integrated circuits ideally suited for easy and convenient design of a step−down switching regulator (buck converter). All circuits of this series are capable of driving a 1.0 A load with excellent line and load regulation. These devices are available in fixed output voltages of 3.3 V, 5.0 V, 12 V, 15 V, and an adjustable output version. These regulators were designed to minimize the number of external components to simplify the power supply design. Standard series of inductors optimized for use with the LM2575 are offered by several different inductor manufacturers. Since the LM2575 converter is a switch−mode power supply, its efficiency is significantly higher in comparison with popular three−terminal linear regulators, especially with higher input voltages. In many cases, the power dissipated by the LM2575 regulator is so low, that no heatsink is required or its size could be reduced dramatically. The LM2575 features include a guaranteed ±4% tolerance on output voltage within specified input voltages and output load conditions, and ±10% on the oscillator frequency (±2% over 0°C to 125°C). External shutdown is included, featuring 80 A typical standby current. The output switch includes cycle−by−cycle current limiting, as well as thermal shutdown for full protection under fault conditions. Features • 3.3 V, 5.0 V, 12 V, 15 V, and Adjustable Output Versions • Adjustable Version Output Voltage Range of 1.23 V to 37 V ±4% Maximum Over Line and Load Conditions • Guaranteed 1.0 A Output Current • Wide Input Voltage Range: 4.75 V to 40 V • Requires Only 4 External Components • 52 kHz Fixed Frequency Internal Oscillator • TTL Shutdown Capability, Low Power Standby Mode • High Efficiency • Uses Readily Available Standard Inductors • Thermal Shutdown and Current Limit Protection • Moisture Sensitivity Level (MSL) Equals 1 • Pb−Free Packages are Available* Applications • Simple and High−Efficiency Step−Down (Buck) Regulators • Efficient Pre−Regulator for Linear Regulators • On−Card Switching Regulators • Positive to Negative Converters (Buck−Boost) • Negative Step−Up Converters • Power Supply for Battery Chargers

评论

发表评论

此博客中的热门博文

Texas Instruments LM3940IMPX-3.3/NOPB 1 Output 3.3V 1A SOT-223-4

Categories Integrated Circuits (ICs) PMIC - Voltage Regulators - Linear Manufacturer Texas Instruments Series- Packaging Digi-Reel® Part Status Active Output ConfigurationPositive Output Type Fixed Number of Regulators 1 Voltage - Input (Max) 7.5V Voltage - Output (Min/Fixed) 3.3V Voltage - Output (Max)- Voltage Dropout (Max) 0.2V @ 100mA Current - Output 1A PSRR- Control Features- Protection Features Over Temperature, Short Circuit Operating Temperature-40°C ~ 125°C Mounting Type Surface Mount Package / Case TO-261-4, TO-261AA Supplier Device PackageS OT-223-4 Base Part Number LM3940 For best overall performance, place all the circuit components on the same side of the circuit board and as near as practical to the respective LDO pin connections. Place ground return connections to the input and output capacitor, and to the LDO ground pin as close to each other as possible, connected by a wide, component-side, copper surface. The use of ...
阅读全文

LM1875T Texas Instruments IC AMP AUDIO PWR 30W AB TO220-5

Categories Integrated Circuits (ICs) Linear - Amplifiers - Audio Manufacturer Texas Instruments Series- Packaging Tube Part Status Active Type Class AB Output Type 1-Channel (Mono) Max Output Power x Channels @ Load 25W x 1 @ 8 Ohm Voltage - Supply 16 V ~ 60 V, ±8 V ~ 30 V Features Short-Circuit and Thermal Protection Mounting Type Through Hole Operating Temperature 0°C ~ 70°C (TA) Supplier Device Package TO-220-5 Package / Case TO-220-5 Formed Leads Base Part Number LM1875 The LM1875 has a sophisticated thermal protection scheme to prevent long-term thermal stress to the device. When the temperature on the die reaches 170°C, the LM1875 shuts down. It starts operating again when the die temperature drops to about 145°C, but if the temperature again begins to rise, shutdown will occur at only 150°C. Therefore, the device is allowed to heat up to a relatively high temperature if the fault condition is temporary, but a sustained fault will limit the m...
阅读全文

Texas Instruments LM1875T/LF02 IC AMP AUD PWR 20W MONO TO220-5

Design Resources Development Tool Selector Featured Product Create your power design now with TI’s WEBENCH® Designer PCN Assembly/Origin Mult Devices 21/Aug/2017 Online Catalog Class AB Amplifier Categories Integrated Circuits (ICs) Linear - Amplifiers - Audio Manufacturer Texas Instruments Series- Packaging Tube Part Status Active Type Class AB Output Type 1-Channel (Mono) Max Output Power x Channels @ Load 25W x 1 @ 8 Ohm Voltage - Supply 16 V ~ 60 V, ±8 V ~ 30 V Features Short-Circuit and Thermal Protection Mounting Type Through Hole Operating Temperature 0°C ~ 70°C (TA) Supplier Device Package TO-220-5 Package / Case TO-220-5 Formed Leads Base Part Number LM1875 The LM1875 has a sophisticated thermal protection scheme to prevent long-term thermal stress to the device. When the temperature on the die reaches 170°C, the LM1875 shuts down. It starts operating again when the die temperature drops to about 145°C, but if the temperature aga...
阅读全文